Follow

How do I pair the new Sensor with the Paragon System?

Plug in your Paragon System and make sure it is fully powered. The unit should default to DIRECT MODE. Simultaneously press RAPID PRECISE & GENTLE PRECISE buttons until the display shows "Unbi". This will unbind the old sensor from the Paragon System.  Turn on the new Paragon Sensor by holding the power button for 3 seconds. The display will show "SYNC" when connected to the new Sensor. This procedure can be followed to unpair and pair any Paragon Sensor.

Was this article helpful?
0 out of 0 found this helpful

0 Comments